Close locks on both poles.
Open locks on both poles.
Insert your graphic into Telescoping AnoGotcha Stand.
Step 6
AnoGotcha is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSTeleAnoGotchaStand
35 Congress Street, Salem, MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Open locks, raise top bar to tension graphic, snap locks closed.
Step 7
Incept-12.09.02
• Open locks on both poles.
• Raise top bar to
tension graphic.
• Snap locks closed.
Your AnoGotcha stand is now
complete and ready for display.
Your completed Telescoping AnoGotcha
Stand should look similar to this.
Insert graphic into top
AnoGotcha holder.
Snap the holder shut.
Snap the holder shut.
Insert graphic into bottom
AnoGotcha holder.
Poster inserted into top AnoGotcha holder.
Poster inserted into bottom AnoGotcha holder.
For each pole, place foot
on base and raise top bar
to tension graphic.
If you have any questions about your Telescoping AnoGotcha Stand assembly,
please call Rose Displays at 1-800-631-9707, ext. 5510 and we will assist you.
AnoGotcha
™
Stand
assembly continued
Te l e s c o p i n g
• Snap open top AnoGotcha
holder completely. Slide
graphic into holder until it
reaches inside top of
Gotcha. Snap AnoGotcha
holder shut. It is easiest to
close the holder by starting
at one end and working your
way to the other end.
• Repeat for bottom
AnoGotcha holder.