Insert T-Gotcha holders into AnoGotcha shells.
Step 3
AnoGotcha
™
Stand
assembly continued
• Slide one T-Gotcha holder
into each AnoGotcha shell.
• Attach one shaped end
cap onto each end of both
AnoGotcha shells.
AnoGotcha is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSAnoGotchaStand
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Attach top AnoGotcha holder onto vertical poles.
Step 4
• Slide one threaded rod with
ball knob (created in step 1)
through top hole in one
vertical pole (created in
step 2).
• Slide threaded rod
completely through top
channel of one AnoGotcha
holder (created in step 3)
and through top hole of
second vertical pole.
• Screw second ball knob
onto other end of threaded
rod. Tighten securely.
Slide T-Gotcha holder into each
AnoGotcha shell as shown.
Attach one shaped end cap onto
each end of AnoGotcha holders,
as shown.
You should have two AnoGotcha holders with one
shaped end cap on each end.
Slide threaded rod through the
top hole of one vertical pole and
then through top channel of one
AnoGotcha holder.
Slide threaded rod through top hole
in second vertical pole. Screw ball
knob tightly onto threaded rod.
Your stand should now look like this.
T-Gotcha
shaped
end cap
vertical
pole
top
AnoGotcha
holder
9” round
base
ball knobs
AnoGotcha
shell
