Turn ball knob in your right
hand away from you.
Hold both knobs and pull down
slightly to tension graphic.
AnoGotcha
™
Stand
assembly continued
Insert your graphic into AnoGotcha Stand.
Step 6
• Open top AnoGotcha
holder and insert top
edge of your graphic
until it reaches the
top of the holder.
Snap shut top holder.
• Open the bottom
AnoGotcha holder and
insert bottom edge of your
graphic until it reaches the
bottom of the holder. Snap
shut bottom holder.
AnoGotcha is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSAnoGotchaStand
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Tension poster and tighten bottom AnoGotcha holder.
Step 7
• Hold both ball knobs on
bottom AnoGotcha holder,
and pull down slightly,
to tighten and straighten
your graphic.
• Turn ball knobs in opposite
directions to secure bottom
AnoGotcha holder.
Your AnoGotcha stand is now
complete and ready for display.
Your completed AnoGotcha Stand
should look similar to this.
Insert graphic into top
AnoGotcha holder.
Snap the holder shut.
Snap the holder shut.
Insert graphic into bottom
AnoGotcha holder.
Poster inserted into top AnoGotcha holder.
Poster inserted into bottom AnoGotcha holder.
To tighten, turn ball knob in
your left hand towards you.
If you have any questions about your AnoGotcha Stand assembly, please call
Rose Displays at 1-800-631-9707 and we will assist you.
