6
ORION LC Installation and Operations Manual
Multiplex Repeater Installation 4 x 4
The 4 x4 configuration allows you to connect four computers to the Orion LC
and display the video of each on a DVI monitor.
To configure Orion LC for a 4 input, 4 output Multiplex Repeater, set the dip
switches and CATx or fiber cabling as shown below. Video received at the
T1 input is transmitted out the R1 output, T2 input out the R2 output, etc.
Set the dip switches so that switch
1, 2, 3, and 5 are all in the “OFF”
position, switch 4 in the “ON”
position.
Each CATx or fiber connector
labeled “T1-4” connects to a KVM
CATx or fiber transmitter.
Connectors labeled “R1-4”
connect to a KVM CATx or fiber
receiver.
(Local keyboard, monitor, and mouse not shown)
Connect a DVI MM cable from
each CPU DVI graphic card to the
DVI-In port on the transmitters
(1-4)
Connect a single CATx or fiber
cable from the transmitters to the
Orion LC ports labeled “T1-4”.
Connect a CATx or fiber cable
from the Orion LC ports labeled
“R1-4” to the receivers.
Connect a DVI monitor to each
receiver’s DVI output
Figure 3. Multiplex Repeater 4x4
The top row of RJ45 connectors has
two LEDs which indicate the LINK
status for the top and bottom RJ45
port. The left LED is for the bottom
RJ45 port status, the right LED is for
the top RJ45 port status.
Orange = Ok
Off = No link
Transmitters
Receivers
Orion LC
DVI Video Cable
CATX Cables
