42
ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL
Appendix D. Rack mount instructions
The UltraView Pro can be mounted in a rack using the Rackmount
kits from Rose Electronics.
The optional rack mount kit includes the following items:
Two black anodized mounting brackets.
Four 6-32 x 3/8” flat head mounting screws.
To rack mount your UltraView Pro, attach the two rack mounting
brackets to your unit with the short flange against the unit using the
four screws provided. Secure the mounting brackets to the rack
using the appropriate size bolts, nuts and lock washers. Using
hardware other than that provided could cause damage to the
electronics and/or result in loss of mounting integrity. Do not over
tighten the screws used to mount the unit to the mounting brackets.
The following general guidelines should be observed when installing
your unit into a rack.
1. The UltraView Pro is designed to work in an ambient
temperature of 0
ο
C to 45
ο
C (32
ο
F – 113
ο
F).
2. Units should be placed (1) rack space apart from each other
and from other equipment.
3. Rack vent panels (1 space) should be installed between units to
provide adequate air flow to the unit.
4. Keep front and rear doors closed on racks equipped with forced
air blowers or fans.
5. Do not block power supply vents or otherwise restrict airflow
when rack-mounting this unit.
6. Mechanical loading of the rack should be considered to prevent
instability and possible tipping over.
7. Tighten all connectors securely and provide adequate strain
relief for all cables.
8. Provide a grounded power source to all units. Pay special
attention to overall branch circuit load ratings before connecting
equipment to this source. Overloaded circuits are potential fire
hazards and can cause equipment failures or poor
performance.
