INSTALLATION
UltraVista Installation and Operations Manual
7
Installation – 2 Video Sources
Installation of two video sources is the same procedure as installing a single video source. First install video source
one as described in the Installation – one video source. Next install the second video source as shown in Figure 4.
Connect the video source to a second video splitter, and connect the splitter’s outputs to the channel 2 inputs
(labeled “2”) on all UltraVista main and extension unit.
With all connections made, initialize the system as described on page 6.
Figure 4. Dual Video source installation
The UltraVista main unit provides the video signal for the first two displays.
The extension units provide the video signal for the other displays
If more than two video sources need to be connected to UltraVista, you can use a video matrix instead of a video
splitter. The following example shows four video sources connected to a 4 x 8 video matrix.
2 x 2 Video Wall Display
3 x 3 Video Wall Display
Main Unit
Extension Unit
1 to 4 Video splitter
1 to 4 Video splitter
Main - A
Main - B
Extn 1-A
Extn 1 - B
Main - A
Main - B
Extn 1-B
Extn 2 - A
Extn 1-A
Extn 2 - B
Extn 3-A
Extn 3 - B
Extn 4 - A