UltraVista Installation and Operations Manual
9
Basic Preset Set-up
Basic presets are used for creating a video wall with displays of the same type and size arranged in a grid pattern
where all gaps (horizontal and vertical) between the displays are equal.
To define the Basic presets, call up the OSD by pressing the “EXIT” and “SELECT” buttons simultaneously for 3
seconds. When the OSD displays, use the
buttons to select (highlight) “SYSTEM” and press the select button.
The system menu will display as shown below. Select “PRESET TYPE” and from that menu, select “BASIC”. Next
select “PRESET” and define the parameters for each preset (1 – 4) and sub-presets (F1 or F2 if needed).
NOTE: THE SYSTEM MUST FIRST BE INITIALIZED PRIOR TO DEFINING THE PRESETS.
Figure 6. Configure Presets (Basic)
To define a basic preset, set the Preset
parameters for each screen.
Target:
Video board the preset is
applied to:
Preset No;
1, 2, 3, or 4
Sub preset:
F1 or F2
Channel:
The input channel this
display shows (1 or 2)
Wall size:
The width and height of the
video wall (x by y)
Position
Position of the display on
the video wall (1-n)
