CRYSTALVIEW PLUS USB INSTALLATION AND OPERATIONS MANUAL
15
Reset keyboard and mouse
– [F1]
Pressing the [F1] key while in the command mode will reset the keyboard
and mouse, and then exit the command mode. Use this command if the
keyboard or mouse lock up or the mouse does not initialize properly.
Send NULL mouse byte
– [F3]
Pressing the [F3] key while in the command mode will send a NULL byte to
the system and then exits the command mode. Use this command to re-
synchronize an out of sync mouse. This command may need to be issued
several times to re-sync the mouse.
Reset to factory defaults
– [L-Ctrl] + [F9]
The reset to factory default command will reset the HF and LF equalization
values, all color delay values and all configurations for all channels back to
the original factory defaults and then exit the command mode.
Toggle Unit Private Mode
– [Scroll Lock]
CrystalView Plus USB models with local KVM access have a private mode
available which can inhibit the local unit’s monitor. When the remote unit
issues this command, it blanks the monitor and prevents the other unit from
being used until the private mode command is issued again. To indicate
that a unit is in the private mode, the scroll lock LED will slowly flash. To
cancel the private mode, enter the Command Mode and press the Scroll
Lock key again.
Local unit Keyboard commands
To initiate a local unit keyboard command, first press the “HOT-KEY” then
the command. The default “HOT-KEY” is the right control key. To change
the default “HOT-KEY” from the right control key to the left control key, enter
the Command mode and press [F7]. This toggles the “HOT-KEY” from the
right control key to the left control key. When the [F7] key is pressed, the
“HOT-KEY” change is saved and the unit exits the Command mode and
returns to normal operation.
The remote user can start a session by pressing the “HOT-KEY” (right
control key), then the scroll lock key. When the remote unit is in the private
mode, the Scroll Lock LED on the local unit flashes and all three LEDs on
the remote unit will illuminate. The local monitor is blanked.