CRYSTALVIEW PLUS USB INSTALLATION AND OPERATIONS MANUAL
31
Appendix E. Quick Installation/Setup Guide
This appendix provides a quick installation and video compensation guide
for experienced users. Refer to the complete installation guide for a more
detailed set of instructions.
Install units
1. Connect Remote unit to KVM, serial & audio devices, additional
video monitors and power
2. Connect Local unit to Computer or KVM switch
3. Connect Local unit to Remote unit with CAT5, CAT5e, or CAT6
cable
4. Apply power to all equipment
Select video channel to adjust
5. Enter Command Mode then select Channel 1, 2, 0 (all)
Display Video test card
6. http://www.rose.com/htm/crvtestcard.htm
Reset selected channel
7. <left Control> + <Home>
Apply Assisted EQ
8. <Left Control> + <Page Up> (Next)
<Left Control> + <Page Down> (Previous)
Adjust Skew
9. Adjust individual color delays until test card’s RED/GREEN/BLUE
vertical lines are aligned.
<See Table 1 for commands>
Fine tune LF and EQ values
10. <See Table 1 for commands>
Exit Command mode and save
11. <ESC>