Rosen Aviation
Remote Display System
Document Number: 105478
Revision: F
Date: 06/23/14
Template: 4.4.1.6FM2; Revision A; 12/06/12
Page 21 of 38
9.3.4.5. RGB Phase
(RGB only)
Use RGB Phase to adjust the default phase value used for RGB signals.
Each RGB video source can have different phase values, which can result in the
RGB video image appearing to jitter. RGB Phase enables you to adjust the RGB
video image to eliminate jitter.
From the
Image Adjust
Advanced
submenu, press the
▼
button to choose
RGB Phase
and then press
ENTER
to open the control bar, as shown below.
Press the
►
button to increase the RGB phase value until the jittering stops.
Press
ENTER
to set the phase value and close the control bar.
Figure 21 RGB Phase control bar
9.4. Info
Use the Information page to review operating status, view details about the display, and access
the Technician Menu.
To open the page, press the
INFO
button on the remote, or use the ▲▼ buttons from within the
Main Menu and navigate to Info.
Notes:
Press ENTER or the
►
button to highlight the Back option—required to access the
Technician Menu.
The Firmware (FM) fields vary by model and are subject to change.
Figure 22 Info page
Back option
active
Use Info to
verify video
source and
resolution
settings
