Page - 96 -
© 2014
SLF 2250/4000
Hydromatic Stinger
Maintenance
Maintenance Procedures - Washing the vehicle
At less frequent intervals, after washing and leathering the vehicle
thoroughly, apply an approved body polish to impart a brilliant,
water-resistant and lasting finish to the paintwork. Never rub the
vehicle down with a dry cloth when it is dirty because this causes
cracks in the paintwork which progressively destroy it. Do not try
to polish with crude oil or grease because this may cause serious
damage to paintwork in a short period of time.
Any tar or asphalt spots on the body may be removed with a tar
cleaner and the use of a soft cloth.
Chrome plated parts
Great care should be taken that the chrome plated parts of your
vehicle are kept clean and free from rust. These parts should be
cleaned periodically with an approved chrome cleaner.
Upholstery
Upholstery of the PVC-type can be suitably cleaned with a reliable
interior cleaner. Never use polishes, oils, petroleum, or a dry cleaning
fluid.
Cleaning of 3M Scotchcal™ and Controltac™ films
Cleaner:
Logos and text made of Scotchcal and Controltac films can be
cleaned with normally available car cleaning products, as long as
these do not contain abrasive particles or organic thinners.
Cleaning:
Please refer to the "Washing the vehicle" chapter.
Car wash:
Scotchcal and Controltac films are car wash safe.
ATTENTION !
It is not allowed to wash a vehicle within the first 48 hours after
decals are applied.
