ROSIERES PCDVF11CPN, Use And Maintenance Manual

 Applying the seal 

Important - The figure below shows how the seal must be attached all around the perimeter. 

This cook top has been designed for non-professional, domestic use. 

 13

 Coupling two or more Domino cook tops  

 
Cut out the work top to allow for the flush mounting of two or more Domino cook tops. 
First of all, place the steel supporting element (E) provided in the package in position, then insert the cook top (G) as 
illustrated in the figure below., Insert the second cook top (F) in the remaining space. 
Together with the seal on the two Domino cook tops, the steel support will ensure that the top is watertight. 
The Domino cook tops are fixed to the work top using the kit of brackets provided. 
 

                                   F 

G 

2. Electric connections 

 
Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated mains 
voltage and power available are suitable for its operation. 
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top is 
compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property deriving from 
failure to comply with this requirement. 
For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. The cord’s 
earthing conductor is colored yellow and green. The plug must be accessible. 
If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 
mm between the cook top and the mains. 
To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts 
inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the terminal block 
cover again immediately. 
If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line 
conductors. 
Use only rubber cable type H05RR-F; the cross-section of the wires must be 3x1.5 mm. 
 
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance is in 
accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of 
25/01/92. 
 

CE 

Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent revisions.