ROSIERES RIED7340BV, Instructions For Use And Installation

Installing a domestic appliance can be a complicated operation which if not carried out correctly, can seriously affect consumer
safety. It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in
accordance with the technical regulations in force. In the event that this advice is ignored and the installation is carried out
by an unqualified person, the manufacturer declines all responsibility for any technical failure of the product whether or not
it results in damage to goods or injury to individuals.

13 GB

  BUILT-IN

The furniture in which your hob will be installed and all adjacent
furniture, should be made from materials that can withstand high
temperatures. In addition, all decorative laminates should be fixed
with heat-resistant glue.

Installation:

• A watertight seal is supplied with the hob.
• It it important to fit the hob on a level supporting  surface.
• Deformations caused by incorrect fitting can alter the specifications

of the worktop and the performance of the hob.

• Leave  a  gap of at  least  5 cm between the appliance and  any 

neighbouring vertical surfaces.

• It is absolutely essential that the recess conforms with  the

dimensions indicated.

•You can not build the hob in above an  oven with  no fan, a

dishwasher, fridge, freezer or washing machine.

INSTALLATION

• The yellow/green wire of the power supply cable must be

connected to the earth of both power supply and appliance
terminals.

• The manufacturer cannot be held responsible for any accidents

resulting from the use of an appliance which is not connected
to earth, or with a faulty earth connection continuity.

• Any queries regarding the power supply cord should be referred

to After Sales Service or a qualified technician.

"The installation must conform to the standard directives."
The manufacturer  declines all responsibility for any damage that
may be caused by unsuitable or unreasonable use.

Warning :

• Always check before any electrical operation, the supply tension

shown on the electricity meter, the adjustment of the circuit-
breaker, the continuity of the connection to earth to the installation
and that the fuse is suitable.

• The electrical connection to the installation should be made via

a socket with a plug with earth, or via an omnipole cut-out switch
with an opening gap of at least 3 mm.

If the appliance has a socket outlet, it must be installed so that
the socket outlet is accessible.

  ELECTRICAL CONNECTION

• Cut a hole  in the worktop of the  dimension  shown  in  the 

diagram below.A minimum of 50 mm space should  be  left
around the hole.

• The worktop  should  be at least 30 mm thick and made of 

heat-resistant material.As shown in the Figure(1)

• It  is  essential  that the induction hob is well ventilated and

that the air intake and exit are not blocked.

Make sure the hob is correctly installed as shown in Figure(2)

JIKI D HJ

JIKI D JJ

JIKI B HJ

A`i `ekXb\

A`i \o`k

NB: For safety, the gap between the hob and any cupboard

above it should be at least 760mm.

Connection to power supply 

The socket shall be connected in compliance with the relevant

standard,  to  a  single-pole circuit breaker.  The method of
connection is shown in Figure(3):

Seal

Grey

The cable must not be bent or compressed.

be  carried out the by  sale agent  with dedicated tools to avoid 

any accident.

• I f the cable is damaged or to be replaced, the  operation  must

L1

L2

N1

N2

56    cm

+0.4
+0.1

49    cm

+0.4
+0.1