40
4. TRANSPORTATION AND HANDLING
The machine is placed on a pallet and ship-
ped enclosed in special package (
Fig. 19
)
fastened to the wooden pallet with straps.
Besides the machine, the package includes:
a disassembled trolley, when requested, with
machine support wheels, operating instruc-
tions and a declaration of compliance with
the EU directive. The accessories supplied
and cutting unit are placed inside the dough
preparation tank (
Fig. 20
), adequately
packaged and protected.
When unloading the machine from the tran-
sport vehicle, lift at the points marked on the
packaging using suitable equipment.
Unless you need to check the contents, you
are recommended not to open the packaging
until the moment of installation.
Remove straps, packing and polystyrene
strips.
Dispose of this material according to the
regulations in force. Lift the machine and
place on the installation site.
Remove the supporting pallet using straps of
suitable carrying capacity (approx. 6 times
the weight of the machine).
These will have to be positioned near the
feet as indicated in
Fig. 21
.
The whole operation is to be controlled by
adequate manual or power-driven lifting
equipment.
Machine fitted with a trolley and wheels
Assemble the trolley, tightening right down
the leg screws (
Fig. 22
) and the wheels
nuts (
Fig. 22
).
Then lift the machine about 20-25 mm.
above the height of the trolley, ensuring that
the clamped wheels (
Fig. 22
) are in the
front of the machine.
Then lower machine until it rests on trolley,
perfectly retained by leg corners.
The machine must be lifted and pla-
ced on the trolley by two persons.
Make sure that the trolley support level is
horizontal and compact.
The machine must be moved horizontally
by carefully pushing the unit from the
C
B
A
Fig. 22
A
A
B
Fig. 19
Fig. 20
Fig. 21
Mod. TR 75÷95÷110
C
