48
8. MACHINE WHIRR
The whirring noise emitted by the machine has been measured on an identical sample
machine in compliance with standard DIN 45635. A constant value not exceeding 70 dB(A)
was measured as stated in the manufacturer’s test report.
9. STRIPPING-DOWN AND DEMOLISHING THE MACHINE
If the machine needs to be stripped-down and/or demolished, its components do not entail a
degree of danger that require any particular precaution.
Remember, however, that to facilitate material recycling operations, it is a good rule to remo-
ve electrical system components from the machine.
10. PROBLEMS AND THEIR SOLUTIONS
PROBLEMS
CAUSES
SOLUTIONS
1) Machine operation
• disconnected plug
• connect plug
failure
• plug leads not
• check lead connections
correctly connected
• trip switch adjusted for
• adjust trip switch
insufficient values
accordingly
• unsuitable trip switch
• replace trip switch
• fuses burnt out
• replace fuse
• safety lever on pool lid
• position the lever at
not properly inserted
end of stroke
2) Problems on the product:
The product gets stuck
• too humid dough is used
• reduce the quantity of water
when being poured out
used for the dough respecting
the abovementioned
percentage
The product looks
• too short kneading time
• increase the kneading time
unacceptable even after
• not enough water
• increase the quantity of
the initial minutes:
percentage
water in order to respect
it breaks and loses flour
the aforementioned
percentage
The product does not
• the blocking of the
• disassemble and clean
come out of the drawplate
drawplate because
the drawplate
of dried dough
The product crushed
• cutting speed not
• increase cutting speed:
at an edge during cutting
adequate (too low)
remember that the length
of the pasta cut, depends
on the pasta and drawplate
diameter
INFORMATIVE REPORT TO THE CUSTOMERS
According to the art.13 of Decree Legislative 25 July 2005, n.151 “Performance
Directives 2002/95/CE, 2002/96/CE and 2003/108/CE, relative to the reduction of the use
of dangerous substances in the electronic and electrical equipment, let alone to dispos-
al of the refusals”.
The symbol of the crossed bin brought back on the equipment or its packing indicates that the product at
the end of its own life cycle must be collected separately from the other refusals.
The differentiated collection of the present equipment at the end of its life cycle is organized and is man-
aged from the producer. The customer who want to unravel itself the present equipment will have there-
fore to contact the producer and follow the system that he has adopted in order to concur the separate col-
lection of the equipment at the end of its life cycle.
The adapted differentiated collection for the successive start of the cast-off equipment to the recycling, to
the treatment and to the compatible with environment disposal contributes to avoid possible negative
effects on the atmosphere and the health and favours the re-employment and/or the recycling of the mate-
rials of which the equipment is made.
Illicit disposal of the product by the holder involves the application of the previewed administrative
endorsements from the enforced norm.
EN 50419
