6 • Installing a Crosspoint Module
Installing a Crosspoint Module
To install the Crosspoint module, you must remove the plate from the Crosspoint
module, install the plate into the module slot in the control panel, and then install the
Crosspoint module onto the plate.
1.
Remove the five (5) Retaining Screws securing the plate to the Crosspoint
module and remove the plate.
Retaining Screw Holes
Figure 2: Crosspoint Module and Plate
2.
Slide the Crosspoint plate into the open module slot that you want to install
the module into.
3.
Install the four (4) Retaining Nuts located at each corner of the Crosspoint
plate to a maximum torque of 5 in-lbs (6 cm-kg). A ¼ inch hex driver or
wrench is required.
Front of Control Panel
Retaining Nuts
Figure 3: Crosspoint Module Plate Retaining Nuts
4.
Align the Crosspoint module so the Retaining Screw Holes on the
Crosspoint module line up with the mounts on the Crosspoint plate.
5.
Using the screws obtained from removing the Crosspoint plate from the
Crosspoint module, secure the Crosspoint module to the Crosspoint plate.
Next, you must install the Module Control Link cables and the Module Power cable
to the Crosspoint module.
