ACO-2200 User Guide (v5.0)
DashBoard Menus • 31
Network Tabs
The Network tab provides two sub-tabs: Ethernet and SNMP.
Figure 7.3 Example of Slot 16 - System Setup — Network Tabs
Ethernet Tab
The
Ethernet
tab allows the user to configure and control the behavior of the Ethernet system within the
ACO-2200. Before proceeding, the user must contact their Network Administrator, and obtain suitable IP
addresses, etc., that will need to be programmed within this menu.
SNMP Tab
This tab is not implemented.
Table 7.4 Ethernet Items
Item
Parameter
Notes
IP address of this
Changeover
#
This menu allows the user to enter the
pre-determined IP address of the ACO-2200.
IP Sub Net Mask
#
This menu allows the user to enter the
pre-determined SubNet Mask address of the
ACO-2200
Gateway Address
#
This menu allows the user to enter the
pre-determined Gateway address of the
ACO-2200. Typically, this might be the IP address
of a network hub to which the ACO-2200 is
connected
MAC Address
#
This menu displays the MAC Address (Media
Access Control), a unique, read-only identifier
assigned to network interfaces for communications
on the physical network segment. This value
cannot be changed - the MAC address is stored in a
hardware device. This address is unique to each
ACO-2200, and is also used to provide unique
update keys when enabling options within the unit.
