4-9
MBus Module
Card Retainer
Figure 4-9. Installing the MBus Module
5. Push the module connector down into the socket as shown in Figure 4-9.
Hold the corners of the MBus module and press down firmly until the module is seated.
Caution: Excessive force may bend or damage pins.
Note: MBus slot 0, the lower slot, must have a module installed or the system will not function.
The top, upper slot—MBus slot 1—is optional and is used only for systems with a dual-module configuration.
6. Lock the arms of the card retainers on the module by pushing them over the edge of the module.
If the system has two modules (slot 1 on top of slot 0), install the module in slot 0 first.
Note: Make sure the module is fully inserted into the slot. If the module is not fully inserted into the MBus
slot connector, the card retainers may not lock over the edge of the module.
7. If a module was removed from slot 1, place the exchanged module in the antistatic bag you set aside
when unpacking the hyperSPARC module.
8. Detach the wrist strap and remove and store the antistatic mat.
Summary of Contents for hyperSPARC
Page 2: ...hyperSPARC Module Installation Guide TM...
Page 9: ...1 4...
Page 21: ...2 12...
Page 55: ...5 10...
