32 • Maintenance
OGX-FR Series User Guide (v1.0)
To clean the air filter
1. Brush any loose dust off of the filter.
2. Place the filter under warm running water to remove any remaining dust. On one side of the filter is a foam
filter material. When rinsing, water should flow out of this side.
3. Remove the filter from the water and thoroughly pat dry with a towel to remove any moisture.
To replace the clean, dry filter into the frame door
1. Place the clean air filter across the metal protective screen, orienting it in the same position you found it in
during step 1 of the procedure “
To remove the air filter from the frame door
2. Install the faceplate by gently fitting it back onto the frame door, ensuring the faceplate does not interfere with
the Diagnostic Panel, the
Toggle
button, and the
STATUS
LED.
3. Verify that the side door tabs are seated properly in the cutouts on the frame door bracket.
4. Using a Phillips screwdriver, secure the faceplate using the four screws removed during step 2 of the procedure
To remove the air filter from the frame door
Replacing the Frame Air Filter
Order the Air Filter Replacement Kit (AFK-OGX) from your openGear sales representative before replacing the
frame air filter in your OGX-FR frame.
To remove the old air filter from the frame door
1. Using a Phillips screwdriver, remove the four 3/16”screws (#850-091R) screws that secure the faceplate. Set
the screws aside. (
)
Figure 8.2 OGX-FR — Screw Locations on Front Panel
2. Ensure that the side door tabs are disengaged from the door.
3. Remove the faceplate by gently pulling it towards you while avoiding the Diagnostic Panel, the
Toggle
button,
and the
STATUS
LED.
4. Gently remove the air filter off the metal protective screen that separates the filter from the fans.
To install the new filter into the frame door
1. Place the new air filter across the metal protective screen, orienting it in the same position you found it in
during step 1 of the procedure “
To remove the old air filter from the frame door
2. Install the faceplate by gently fitting it back onto the frame door, ensuring the faceplate does not interfere with
the Diagnostic Panel, the
Toggle
button, and the
STATUS
LED on the frame door.
3. Verify that the side door tabs are seated properly in the cutouts on the frame door bracket.
4. Using a Phillips screwdriver, secure the faceplate using the four screws removed during step 1 of the procedure
To remove the old air filter from the frame door
”.
1 2 3 4
10.xx.x.xx
Slot 4 Error
