TSI-100 User Guide (v5.0)
Hardware Overview • 13
Hardware Overview
This chapter provides a general overview of the user controls available on the TSI-100.
Card Overview
This section provides a general overview of the TSI-100 card components.
Figure 2.1 TSI-100 — Components
If the TSI-100 is installed in a rear module that has a bypass relay, this two-position push-button is used to
control the relay.
› When the push-button is in the
IN
position, the TSI-100 is in the video signal path. It is recommended to set
SW1
in the
IN
position at all times.
› Pressing it once moves the switch to the
OUT
position and bypasses the TSI-100.
› Pressing it again restores the TSI-100 to its active state.
This button is used for rebooting the card.
Control and Monitoring Features
This section provides information on the card-edge LEDs for the TSI-100. Refer to
for the location of
the LEDs.
1) Bypass Switch (SW1)
2) Reset Switch (SW3)
1
2
