FOR ADDITIONAL PROTECTION FROM ELECTRIC SHOCK
It is recommended that this tool be used in conjunction with a residual current device (RCD)
with a rated residual current of 30mA or less.
GENERAL WARNINGS FOR COMPRESSORS
• Do not attempt to modify the compressor in any way.
• The use of any tools or accessory other than those designed for use with compressed air
could result in injury to the operator.
• The output pressure of the compressor should be adjusted to the design pressure of the
air tool or accessory being used.
• Always check that the output of the compressor does not exceed the maximum pressure
for any attached tool or accessory.
• Repairs should only be carried out by qualified persons using original spare parts. Failure
to do so may result in considerable danger to the user.
Breathable Air Warning
This compressor/pump is not equipped and should not be used to supply breathing quality air
for any application of air for human consumption.
Extension Cords and Reels
In general, it is not recommended to use an extension lead. A longer air line is recommended
as voltage drop on extension leads may lead to motor damage and will void warranty. If a ex-
tension cord must be used, for lengths up to 5 metres, an approved 15amp rated cord must
be used.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect it from the mains supply socket. Never
carry or drag your compressor by its power cord. Keep the power cord away from heat, oil,
solvents and sharp edges. If the power cord becomes damaged have it replaced by an author-
ised service facility.
Check Damaged Parts
Before using the compressor it should be carefully checked to determine that it will operate
properly and perform its intended function. Check for the correct alignment of moving parts
ensuring they do not bind. Check for broken or missing parts and have them replaced or
repaired at an authorised service centre. Check any other condition that may affect the opera-
tion of the compressor.
A guard or any other part of the compressor that is damaged should be properly repaired
or replaced by an authorised service centre.
Disconnect Compressor
Ensure that the compressor is disconnected from the mains supply and the tank is empty
when not in use, before servicing, lubricating or making adjustments to air lines when chang-
ing accessories such as blades, bits, nails and cutters on air tools .
Avoid Unintentional Starting
Ensure that the main switch is set in the OFF position before plugging the compressor into
the mains
supply
Summary of Contents for RAAC1.5/15
Page 7: ......