Figure 4: Module Cables
a)
Connect the 4-conductor Module Power
Cable to the module.
This cable delivers power to all of the
modules in the row. When connecting the
cable, ensure that you do not accidentally
unplug it from any neighbouring modules.
b)
Connect both of the CAT5 Module Control
Link Cables to the module.
This cable delivers all of the command
signals to and from the module, as well as
other modules in the same row.
Module Setup
Each module must be set up for the panel row it is
assigned to, and the mapping for the first crosspoint
button or fader on the module. Specialized modules, such
as the Audio Control module, require calibration when
they are first installed.
To Upgrade a PMC
The Panel Module Controllers (PMCs) may need to be
upgraded if you perform a software upgrade or replace
a module. If PMCs need to be upgraded, the message
PMCs need to be upgraded; please go
to Panel Modules menu
is displayed on the Main
Menu.
1.
Press
HOME
>
Setup
>
More
>
Panel
Modules
.
A warning is displayed, asking you if you want
to enter the menu. Press
Yes
.
2.
Press
Upgrade PMCs
.
To Map an Audio Module to a Panel Row
1.
Press
HOME
>
Setup
>
More
>
Panel
Modules
.
A warning is displayed, asking you if you want
to enter the menu. Press
Yes
.
2.
Press a button, or move a fader, on the module
you want to map.
The name of the module and the Link and Node
that the module is on are displayed. If the name
does not match the module you are installing,
ensure that another button on the panel is not
being pressed.
3.
Press
Panel Row & Crosspoint
.
4.
Use the
Panel Row
knob to select the panel
row that you want to assign the module to. You
can select either an internal row (Row 1 to Row
8) or an external row (Row 1 to Row 16).
5.
Press
Audiofader
.
6.
Use the
First Fader
knob to select the number
of the first audio fader on the module you are
setting up.
Each Audio Control module has 8 audio faders,
the first audio fader on module 1 is 1, the first
audio fader on module 2 is 9.
To Calibrate an Audio Fader
1.
Press
HOME
>
Setup
>
Installation
>
More
>
Calibration
>
ADC Calibration
.
2.
Move each audio fader from the top to bottom
limit. Repeat this for each audio fader on the
module.
3.
Press
Accept
.
2
