Valve Body Service Kits.
These kits, listed at the right, contain all parts needed
for a complete reconditioning of a valve body. Included are a spindle, all poppets
and spacers, all required gaskets and seals, detent assemblies for valves using
them, and instructions for use.
Valve-to-Base Gasket.
If your valve is removed from its base for any reason, a
new valve-to base gasket must be used to ensure a leak-free seal. (This gasket
is already included in valve body service kits.)
Solenoid Coils:
Replacement coils for solenoid controlled valves can be
ordered by part number listed in the table below.
Complete Solenoid Pilot Assemblies:
These assemblies consist of new pilot
valve mechanisms and a new solenoid coil, ready to bolt in position on the valve.
VALVE SERVICE
5/2 SINGLE CONTROL VALVES
Pressure Controlled
Solenoid Pilot
No Signal Applied:
Inlet 1 connected to outlet 2; outlet 4
connected to exhaust 5; exhaust 3 closed.
Signal 14 Applied:
Inlet 1 connected to outlet 4; outlet 2
connected to exhaust 3; exhaust 5 closed.
5/2 MOMENTARY CONTROL VALVES
Pressure Controlled
Solenoid Pilot
Signal 12 Applied Momentarily:
Inlet 1 connected to outlet 2;
outlet 4 connected to exhaust 5; exhaust 3 closed.
Signal 14 Applied Momentarily:
Inlet 1 connected to outlet 4;
Outlet 2 connected to exhaust 3; exhaust 5 closed.
rosscontrols.com
3
VALVE OPERATION
Valve Model
Number
Valve Body
Service Kit
Valve-to-Base
Gasket
W6456B2411
1017K77
617B11
W6456B2412
1014K77
617B11
W6456B2417
834K77
617B11
W6456B2418
843K77
617B11
W6456B3411
1018K77
618B11
W6456B3412
1015K77
618B11
W6456B3417
835K77
618B11
W6456B3418
844K77
618B11
W6456B4411
1019K77
619B11
W6456B4412
1016K77
619B11
W6456B4417
836K77
619B11
W6456B4418
845K77
619B11
W6476B2401
1017K77
617B11
W6476B2402
1014K77
617B11
W6476B2407
834K77
617B11
W6476B2408
843K77
617B11
W6476B3401
1018K77
618B11
W6476B3402
1015K77
618B11
W6476B3407
835K77
618B11
W6476B3408
844K77
618B11
W6476B4401
1019K77
619B11
W6476B4402
1016K77
619B11
W6476B4407
836K77
619B11
W6476B4408
845K77
619B11
Voltage
Complete Solenoid
Pilot Assemblies
Replacement
Solenoid Coils
Part Number
Part Number
24 volts DC, 48 volts AC
851C79165
306K33165
110-120 volts AC, 48 volts DC
851C79166
306K33166
210-220 volts AC, 110 volts DC
851C79167
306K33167
ROSS would be happy to service this valve for you at its factory repair center.
If you purchased your valve from ROSS please contact ROSS customer
service, if you purchased your valve thru an authorized ROSS distributor
please contact the distributor for return instructions.
However, if you choose to service this valve yourself, it is strongly
recommended that you visit our website at rosscontrols.com
for available downloadable technical documentation.
Electrical
Connector
Electrical Connector Type
Cord Length
meters (feet)
Cord
Diameter
Electrical Connector Model Number
Without
Light
Lighted Connector
*
24 Volts DC
120 Volts AC
EN 175301-803
Form A
Prewired Connector (18 gauge)
2 (61/2)
6-mm
721K77
720K77-W
720K77-Z
Prewired Connector (18 gauge)
2 (61/2)
10-mm
371K77
383K77-W
383K77-Z
Connector for threaded conduit
(1/2 inch electrical conduit fittings)
–
–
723K77
724K77-W
724K77-Z
Connector Only
–
–
937K87
936K87-W
936K87-Z
*
Lights in connectors with a translucent housing can be used as indicator lights to show when solenoids are energized.
