neeD
ASSISTANCE?
Safe T Serv™ 200
Instruction Sheet
Automatic Bulk Dispenser
Instruction Sheet | Model: DS206
neeD AssistAnCe
?
Customer Service Support: 1300 81 30 40
www.topshelfconcepts.com
the bulk DisPenser bACk PAnel
testing the oPerAtion
1. Plug the Power Supply (j) into a 120 volt receptacle.
Plug the Barrel Plug into the Input Jack on the back
of the Stand.
2. The ON/OFF power switch is located on the back of
the Stand. Once turned on, blue LEDs will appear at
the front of the Stand indicating
that the Dispenser is
turned on.
On/OFF Switch
Figure A
Container #2
Container #1
Power
Supply (j)
Input Jack
Barrel Plug
Programming
Switches
3
.
To test the operation, place a cup/bowl on the Catch Tray
(i). Push the cup/bowl against the Lever located below
a Container. The Paddle Wheel (b), will turn for 2–4 sec-
onds and the LED will turn
from blue to green. Once the
cycle has ended, the LED will
turn blue again and the
Paddle Wheel will stop.
Test the other Container in
same manner.
Lever
Catch Tray (i)
Each of the Containers are programmed separately
using the switches on the back of the Stand. You can set
the speed and the amount of time at which each Paddle
Wheel turns.
Switches 1 and 2 are used to program Container 1.
Switches 3 and 4 are used to program Container 2.
ProgrAmming the ContAiners
Switch
Position
Container 1
Switch 1
Rotation
Time
4
Seconds
Switch 2
Rotation
Speed
Fast
UP
DOWN
Switch 3
Rotation
Time
4
Seconds
Switch 4
Rotation
Speed
Fast
Switch 5
Rotation
Time
Switch 6
Rotation
Speed
N/A
N/A
N/A
N/A
2
Seconds
Slow
2
Seconds
Slow
N/A
N/A
N/A
N/A
Container 2
Container #1 Paddle rotates
4 Seconds at SLOW speed.
Container #2 Paddle rotates
2 Seconds at FAST speed.
Programming Example
