Wiring Instructions
Swipe Family Readers Installation Manual
Page 10
5
Wiring Instructions
Mifare
®
Smart Card Fingerprint Swipe Sensor MOC Readers are
supplied with a 7- wire, 18-inch cable.
To connect the Reader to the Controller:
1. Prepare the Reader cable by cutting the cable jacket
back 1¼ inches, and by stripping the wires ½ an inch.
2. Prepare the Controller cable by cutting the cable jacket
back 1¼ inches, and by stripping the wires ½ an inch.
3. Splice the Reader pigtail wires to the corresponding
Controller wires (see Table 1), and cover each connection.
4. If the Tamper output is being utilized, connect the purple
wire to the correct input on the Controller.
5. Trim and cover all conductors that are not used.
Table 1: Wiring the Reader to the Controller
Color Wiring
Black/ Shield
Ground
Red Vin
Green Data
0
White Data
1
Brown LED
control
Orange Buzzer
control
Purple Tamper
Note:
•
The individual wires extending from the Reader are color-
coded according to the required Wiegand standard.
•
When using a separate power supply for the Reader, this
supply and the Controller’s power supply must have a
common ground. A linear power supply is
recommended.
•
Attach the cable Shield wire on the Reader to an earth
ground (best), or to a signal ground connection at the
panel or power supply end of the cable. This
configuration is best for shielding the Reader cable from
external interference.
