Testing the Reader
Swipe Family Readers Installation Manual
Page 12
7
Testing the Reader
After wiring the Reader to the Controller and to a power
supply, test the Reader.
To test the Reader:
1. Power up the Reader. 3 long beeps are generated, and all
3 LEDs flash simultaneously for 3 seconds. After 30 seconds,
the LEDs illuminate alternately, from top to bottom.
2. Present the appropriate type of card to the Reader. If the
card is valid and contains a fingerprint template, a short
confirmation beep is generated, and all 3 LEDs will flash
indicating successful read.
3. Following the confirmation, the LEDs will turn on and off in a
fast circular mode, swipe your finger on the swipe sensor. If
the fingerprint matches the template on the card, three
short confirmation beeps are generated, and all 3 LEDs will
flash indicating successful read. If there is a mismatch, a
long, low beep is generated and the LEDs will turn off for
750mS.