Modes of Operation
Swipe Family Readers Installation Manual
Page 15
•
There is a mismatch between the fingerprint and the
template (e.g., the user presents the wrong finger).
When a card or fingerprint read is invalid, the following
sequence occurs:
1. A user presents a Mifare
®
card to the Reader. This can
occur during Standby mode (at the beginning of the
identification procedure), or following a successful read of
the first means of identification.
2. If the card or fingerprint is wrong the LEDs will turn on and
the buzzer will emit a long, low, invalid indication beep
(750mS) is generated. After this time period, the user can
reattempt card or finger presentation.
3. If there are 5 invalid reads within 30 seconds, the Reader
enters Lockout mode.
If there are fewer than 5 invalid card / fingerprint reads
within 30 seconds, the Reader enters Standby mode.
Note:
When connected and operating with Rosslare’s controllers
and the AxTrax software, the readers send specific
messages when failures occur. Those messages appear
and can be handled on the AxTrax software:
•
Fingerprint data reading from card failed
•
Swipe sensor Fingerprint reading failed
•
Fingerprint swipe sensor / card verification failed
8.5
Lockout Mode
The Reader enters Lockout mode when there are number
invalid card and / or finger reads within a 30 second period.
During Lockout mode, all 3 LEDs flash simultaneously for 1
minute. After 1 minute, the Reader enters Standby mode.
Note:
5 is the default number of invalid reads before the Reader
enters Lockout mode. The number of invalid reads can be
programmed to be 1-10
1 minute is the default duration of Lockout mode. The
duration can be programmed to be 1-5 minutes.