Mounting Instructions
Swipe Family Readers Installation Manual
Page 8
4
Mounting Instructions
Prior to starting, select the location where the controller unit is
to be mounted. Use the supplied drilling template to assist in
locating and drilling the appropriate holes.
AY-B1663
AY-B4663
Figure 4: Mounting orientations
Note:
Be sure to protect the swipe sensor when the Reader is
mounted outside.
To mount the Reader:
1. Determine an approximate surface location for the
Reader.
2. Peel off the back of the self-adhesive mounting label
template and place it on the required mounting location.
3. Using the template as a guide, drill two holes (of the size
indicated on the template) on the surface to mount the
Reader.
4. Insert a suitable wall plug into each hole.
5. Drill a 7/16” (10 mm) hole for the cable. If the surface is
metal, place a grommet or electrical tape around the
edge of the hole.
6. Unscrew and remove the case security screw at the
bottom using the security hex key.
