Connection and Configuration
10
MD-N32 Installation and Operation Manual
3.3.1
Network Connection
Connect each MD-N32 to the LAN using the LAN cables through the
RJ-45 connector on each unit of the MD-N32 (Figure 1).
Figure 1: Front View of the MD-N32
Make sure that the units are connected to the same LAN through a
hub.
3.3.2
Serial Connection
3.3.2.1
Unit Side
Connect the unit to the MD-N32 D9 jack using an RS-232 cable
(Figure 2), or use Rosslare's MD-14 when necessary (RS-485 to RS-232
Converter).
Figure 2: Rear View of the MD-N32
3.3.2.2
PC Side
If the MD-N32 is connected to the PC’s serial port, connect the MD-
N32's D9 jack to the PC using a cross-linked RS-232 cable.
D9-RS-232 Jack
Power Jack
RJ-45 Jack
