Rossofuoco RUBINO, User And Maintenance Manual

page 12

TROUBLE

TROUBLE

POSSIBLE CAUSE

SOLUTION

The heater does not turn 

on

Pyrolysis has not started 

correctly 

Check that the used ecological igniter has 

not been switched off, if it is so to add 

more of it so that its quantity is adequate 

and turn it on again making sure that its 

combustion is well started before closing 

everything.

Wet pellet

Change the wood pellets especially if the 

package was open for some time, without 

throwing it, but maybe reusing it once it 

has dried well; place again some ecological 

fire ignites ensuring their correct ignition.

Failure to comply with the 

indications concerning the 

installation and use of the 

heater

Read carefully this manual and correct

possible errors in installation.

Meticulously follow all instructions.

The flame don’t start up

The flame reducer is missing

Place the supplied flame reducer on top of 

the burner correctly.

Smoke during ignition

Unsuitable igniters

Be sure to use quality igniters

The flame is too intense

there is not enough pellets in 

the burner

Do not intervene and do not interrupt the 

activity of the heater in its combustion 

process, paying close attention to the high 

temperatures it could reach.

At the next ignition, load the 

recommended quantity of wood pellets.

It is not possible to extract 

the burner

The drawer slide guides have 

not been lubricated.

Lubricate the burner drawer guides;

perform this procedure after every 2/3 use.

combustion residues or foreign 

bodies prevent it from flowing

Check for any residues or foreign bodies 

and remove them.