Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-732-4744 - rostra.com
Page
6
Step 12
Step 13
Route the GPS antenna extension harness from the
GPS/Multimedia video interface module to the rear of the
vehicle.
Place the GPS antenna at the top-rear of the vehicle
allowing it to attach to the vehicle’s body using its built-in
magnet.
Reassembly
1.
Reinstall all trim pieces taking special care to ensure harnesses and wiring connections are properly secured.
2.
Make sure no harnesses are bent or pinched by trim pieces.
3.
Reconnect all disconnected bulbs and check for function.
Installation Tips
Confirm proper cable extension connector orientation and always verify proper ends are routed in correct direction.
It is a good idea to dry-fit all pieces in this kit before permanently attaching them to ensure proper orientation and
operation before beginning installation for familiarization with components.
Always treat any metal exposed during installation with a rust preventative compound to prevent system failure due to
rust and/or corrosion.
Always seal any holes drilled with the provided sealing putty to prevent water infiltration through unprotected areas.
Confirm integrity of mechanical and electrical connections before moving to next installation sequence.
Step 14
Step 15
Once all connections have been made, re-assemble the
radio and dashboard.
If indoors, start the vehicle and move it outside so that the
GPS antenna has a clear view of the sky. Press the
mute/call decline button to switch from the factory interface
to the iGo Navigation interface.
