Element 9 Manual
Original instructions
Nov 2019
11
direction.
Move out the HEX wrench and open wrench, then open the lower Blade guard to move over the arbor screw,
flange and blade in turn
Put on the new blade, flange and arbor screw in proper order. Use the open wrench to hold the flange and use the Hex wrench
to fix the arbor screw by clockwise direction
Note: Put the blade in right direction, the arrow on blade must be same direction as arbor turn
CUTTING DEPTH ADJUSTMENT
DIRECTION OF SAWING
Please align the right side’s cut in front
of the base with a level cutting line of workpiece for longitudinal sawing. Trigger on the
switch before the blade touches the workpiece. Wait until the blade attains full speed before cutting. Push the saw into the
workpiece slowly, to ensure that the blade operates at full speed. For a smooth cut surface, keep the saw at full speed while
cutting.
Operation of Switch
Press the stop button first and pull the trigger at the same time to start rotating. To stop rotating, release trigger.
Operation
Please use right hand(A) to hold the rear Handle, and left hand(B) hold the tool after the blade reaches the maximum speed rate
and push forward the tool along the surface of workpiece. Keep moving smoothly till the cut is finished.
