USER'S AND
MAINTENANCE
MANUAL
Date:
01/31/2020
Code
MAN D185T4F-DB
ENG
Air Compressor : D185T4F-DB
Revision 03
Copyright © 2014, ROTAIR S.P.A. - All rights reserved
.
This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
Page
21/59
The user must periodically check the condition of the lifting equipment and
machine-supplied lifting hook and replace it if it is no longer appropriate or safe.
No other hooking and lifting systems are allowed except those that are provided
with the machine.
This pictogram shows the hooking system to lift the machine.
WARNING
OVERHANGING
LOADS
6.2
Safety recommendations concerning lifting
A
purposely-allocated
opening
protected
by
a
rubber cover is
located in the upper panel of the hood and allows for easy
access
to the lifting hook.
List of the operations for the safe lifting of the machine:
1)
Make sure that the lifting device (crane, hoist, etc.) is of the
a
ppropriate payload
for the
weight of the unit and that it is
m
aintained appropriately.
2)
In the case
that the
lifting device
is
installed on
the
truck, use the
s
ide anti-tilting stabilizers.
3)
Attach the hook of the lifting device to the hooking point of
the compressor (Figure 6.2-1).
4)
Lift the unit slowly and without sudden movements to
prevent the load from swaying excessively.
5)
Before transporting, always check that there are no parts
that may fall off during transport.
6)
Check the status of tie
-
downs or chains before starting the transport
operations.
7) In any case, always make sure that the machine is solidly secured to the loading deck of the transport
vehicle and balanced appropriately.
8) Communicate appropriately when the compressor is lifted to or from the transport vehicle.
9) Never leave the lifting area with the compressor hanging.
10) Do not stand or walk under the hanging load.
Figure 6.2-1
