Operation
25
Before operating the machine each time, check and ensure the following:
•
Only authorised persons are in the work area of the machine.
•
No one will be endangered by the starting up of the machine.
•
Measures have been taken to prevent unintended changes in the position of
the load.
•
A clear view is available of the load, the machine and particularly the danger
zone (
).
•
Avenues of escape are available in the event of danger.
7.2
Description of the controls
Fig. 7-1 Control device
1) Control: «Main switch»
Setting the switch to "1" switches on the power supply - control lamp (A) lights
up.
Setting the switch to "0" switches off the power supply - control lamp (A) goes
dark.
The «main switch» can be locked with a padlock. This secures the machine
against unintentional operation.
2) Control: «Lift»
By pressing the «Lift» control, the platform raises.
The movement stops as soon as the control is no longer held pressed (dead-
man control).
3) Control: «Lower»
By pressing the «Lower» control, the platform lowers.
The movement stops as soon as the control is no longer held pressed (dead-
man control).
When the Euro Stop is reached, the lowering motion stops in order to prevent
crushing and other hazards. If the lowering motion is to be resumed, press
Summary of Contents for ML40
