Section 02 717 ENGINE
Subsection 03 (TOP END)
F00B0KA
1
TYPICAL
1. Tool cut-out toward bottom of piston
– Firmly hold puller and rotate handle to pull pis-
ton pin
no. 10
.
– Rotate spindle until the shoulder sleeve is
flushed with the piston recess.
F00B0LA
1
TYPICAL
1. Shoulder sleeve flush with piston recess
– Loosen the extracting nut and remove puller.
– Remove the shoulder sleeve from piston.
F00B0MA
1
TYPICAL
1. Remove shoulder sleeve
Carefully remove the piston
no. 8
.
The needles
no. 11
, thrust washers
no. 12
and the
sleeve remain in the connecting rod bore and may
be used again.
1
2
F00B0NA
TYPICAL
1. Needles and thrust washer
2. Sleeve
CLEANING
Discard all gaskets and O-rings.
Clean all metal components in a solvent.
Clean water passages and make sure they are not
clogged.
Remove carbon deposits from cylinder exhaust
port, cylinder head and piston dome.
Clean piston ring grooves with a groove cleaner
tool, or a piece of broken ring.
smr2005-077
29
www.SeaDooManuals.net
