Section 02 717 ENGINE
Subsection 05 (ROTARY VALVE)
F01D61A
1
1. Hold bolt
F01D27A
Circlip and Spring Seat
If it is necessary to disassemble components of
rotary valve shaft assembly, use seat
no. 6
to com-
press spring and remove circlips
no. 5
.
F01D25A
1
2
1. Compress seat
2. Remove circlips
Shaft Bearing
To remove bearing
no. 8
use a bearing extractor
such as Snap-on no. CJ-950 (or equivalent) as il-
lustrated. Slide off distance sleeve
no. 14
, re-
move snap ring
no. 7
and washer
no. 15
then
press shaft out.
F01D4NA
1
2
1. Bearing
2. Bearing extractor Snap-on CJ-950
CAUTION:
Ensure that rotary valve shaft is per-
fectly perpendicular with press tip.
End Bearing
CAUTION:
Do not remove plug against bearing
in upper crankcase half.
F01D4OA
1
1. Do not remove this plug
End bearing
no. 9
can be easily removed from up-
per crankcase half using the following suggested
tool (or equivalent):
– Snap-on hammer puller including:
• handle CJ93-1
• hammer CJ125-6
• claws CJ93-4.
50
smr2005-079
www.SeaDooManuals.net
