Section 03 787 RFI ENGINE
Subsection 02 (MAGNETO SYSTEM)
Crankshaft Position Sensor
Install crankshaft position sensor
no. 3
on mag-
neto housing. Apply Molykote 111 (P/N 413 707
000) on its O-ring.
Apply Loctite 767 (antiseize lubricant) (P/N 293
800 070) on screw threads then torque it to 9 N•m
(80 lbf•
in
).
NOTE:
The crankshaft position sensor is not ad-
justable.
Cover
Before installing cover, make sure oil pump shaft
is properly positioned. Apply Loctite 767 (anti-
seize lubricant) (P/N 293 800 070) to the end of
shaft.
Before installation, properly install O-ring
no. 16
in
engine magneto cover
no. 2
.
Apply Loctite 767 (antiseize lubricant) (P/N 293
800 070) on screws
no. 1
. Torque screws in a
criss-cross sequence to 9 N•m (80 lbf•
in
).
Apply dielectric grease (P/N 293 550 004) on elec-
trical connections.
70
smr2005-081
www.SeaDooManuals.net
