d0
45
2
7
.f
m
MAINTENANCE MANUAL
BRP-Powertrain
Effectivity: 914 Series
Edition 2 / Rev. 0
05-50-00
page 5
January 01/2010
2) Checking of the overload clutch
General note
In the event of lead deposits and/or if slipping is suspected, it will be nec-
essary to check the overload clutch.
NOTES:
Slipping of overload clutch is apparent if at engine speed
rise, the propeller speed does not increase at the same
rate.
NOTES:
The engine should be run for a short time just prior to the
test, otherwise there is the risk of the clutch „drying out“,
resulting in a higher torque.
Fig. 1
08054
Step
Procedure
1
Remove the propeller as per manufacturers instruction.
2
Lock the crankshaft. See chap. 12-20-00 section:
3
Danger of damage to the engine suspension!
Depending on the engine installation (e.g. in the case
of extremely lightweight engine suspension), the
gearbox must be removed and the test carried out on
a suitable mounting attachment.
A specially prepared lever (e.g. length 1.5 m (4.92 ft.), see Fig.1) is fitted on
the propeller flange and the breakaway torque measured with a suitable
measuring tool.
NOTE:
Because of difficult measurement of the slipping torque
the breakaway torque is measured.
NOTICE
.UDIW)LQ1
IRUFH)LQ1
/lQJH/P
OHQJWK/LQP
Summary of Contents for 914 series
Page 183: ......
