Technical Data
MDR-42
- 33 -
ROTEC technology
9.4.2.12. FAN1, FAN2, FAN3, FAN4, FAN5
rBaseETX can control up to 5 DC fans. The fans can be controlled individually in speed. It will also be possible to
speed up the fans with increasing temperature or vice versa. The control will be done through two ADT7476A
devices. These devices allow several settings and features. For a detailed information about all possible
settings and readings please refer the data sheet of ADT7474A. The electrical restriction can be found in the
following table. According the given values it will be possible to drive 3 fans with a current consumption of
0.5A or to drive 5 fans with a current consumption of 0.3A.
Parameter
Symbol
Type
Unit
Vcc
Supply voltage
12
V
Icc
Supply current FANx
max 0.5
A
Icc_total
Total supply current all FAN's
1.5
A
Table 15: Electrical parameters for FANx
The total current supply Icc_FAN for all FANx connector are restricted to 1.5A.
PIN
Description
Type
1
GND
PWR
2
VCC +12V
PWR
3
Speed signal
IN
Table 16: Fan Pin assignment
9.4.2.13. Temperature Senor
Two additional temperature sensors can connected via the connector T1_SENS and T2_SENS. The ADT7476A
controller measures the voltage at the pn exchange of a simple transistor. For detailed information about the
possible transistors and how to connect them to the ADT7476A refer the data sheet.
PIN
Description
Type
1
D+
Analog
2
D-
Analog
Table 17: Temp.Sensor Pin assignment
Summary of Contents for MDR-42
