Gebrauchsanweisung ○
Mode d’emploi
○
Istruzioni per l’uso
○
Instruction for use
114
Connecting the hob to the mains power supply
o
This hob must be connected to the mains power supply only by a suitably qualified
person.
o
Before connecting the hob to
the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the hob.
2. The voltage corresponds to the value given on the rating plate.
3. The power supply cable sections can withstand the load specified on the rat
ing
plate.
o
To connect the hob to the mains power supply, do not use adapters, reducers, or
branching devices, as they can cause overheating and fire.
o
The power supply cable must not touch any hot parts and must
be positioned so that
its temperature will not exceed 75˚C at any point.
o
Check with an electrician whether the domestic wiring system is suitable without al-
terations. Any alterations must only be made by a qualified electrician.
o
The power supply should be connected in compliance with the relevant standard or
using a single
-
pole circuit breaker. The method of connection is shown below.
400V 2N 7200W 16A
ATTENTION!
This unit is only designed for an operating
voltage of 230V.
Always connect the neutral conductor (N) as
well.
Observe the connection
diagram.
o
If the cable is damaged or needs replacing, this should be done by an after
-
sales tech-
nician using the proper tools, so as to avoid any accidents.
o
If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3 mm between the contacts.
o
The installer must ensure that the correct electrical connection has been established
and that it complies with safety regulations
.
o
The cable must not be bent or compressed.
o
The cable must be
checked regularly and only replaced by a properly qualified person.
