Gebrauchsanweisung ○ Mode d’emploi ○ Istruzioni per l’uso ○ Instructions for use
61
o
A sound signal indicates when the working time is over and the LCD indicator light
keeps flashing.
o
Rotate the knob back to the “OFF” - position and proceed in the reverse order of the
assembly to empty the bowl.
Caution:
o
The temperature icon blinks constantly under this mode, indicating that the heating
function is activated.
o
Beware of escaping steam and drips from hot condensation water: there is a danger
of scalding.
o
Do not exceed the effective filling capacity and do not use without the bowl cover.
o
Avoid touching the bowl and only use the insulating handles to remove it from the
base of the appliance.
Notes:
o
A temperature reset is possible while the appliance is running.
With a set temperature, the appliance will heat up and keep the food to the target
temperature. Without a set temperature, the appliance will heat up to 100
℃
, and
keep the temperature constant at 70
℃
for the remaining set time (Same function
than with the “Rapid heating button”).
o
The speed selecting function is invalid in the heating mode.
Mode 3: heating & stirring mode
o
Attach the required tool (stirring hook), fill up the bowl and lock the mixer head in its
working position (see section “Assemble and use the tools”).
Plug in the appliance and rotate the knob to the “OFF” – position, otherwise, the LCD
indicator light will keep flashing.
o
Press the “Temperature
⇌
Time” button (F) to set a working time (from 1 minute to
3 hours). The LCD indicator light will stop flashing 3 seconds after the time setting.
o
Set the required temperature to heat the food (from 20
℃
to 140
℃
). The LCD indica-
tor light will stop flashing 3 seconds after the temperature setting.
o
The appliance will start processing and count down the scheduled timing. If no time
is set, the time counter runs (1.2.3.4…) and the appliance will stop automatically
working after 3 hours.
o
A sound signal indicates when the working time is over and the LCD indicator light
keeps flashing.
o
Rotate the knob back to the “OFF” - position and proceed in the reverse order of the
assembly to empty the bowl and dismantle the tool.
