ROTH BAR 1
High-power audio for your living room
8 | Roth Bar 1 User Manual
Wall Mounting
Determine how you want to set up your BAR1 and Wireless Subwoofer Audio System.
The BAR1 system comes with a wall mounting kit to be used with a wall mounted TV. The input jacks and power cord
are designed to allow a flush mount where the BAR1 extends only 2” (50 mm) from the wall. Also, the BAR1 is provided
with an extra long power cord so the user may hide the AC line by using a wall track that could be painted to match the
wall.
Follow these steps to mount the BAR1 on
a wall:
1. Measure the width of the TV – the BAR1 should be
mounted so it is centered with the TV. Divide the TV
width measurement by 2 - that will be the centerline
distance from the edges of the TV.
2. If the BAR1 is to be mounted below the TV, measure from
the TV edge to the centerline distance on the open wall
below the TV.
Mark the distance with a pencil 1-1/2“ (38 mm) or
more below the bottom of the TV.
3. Make a pencil mark 10-7/16” (265 mm) on each
side of the centerline. Make sure the mark is the
same distance down from the TV on each side.
4. Make another mark 25/32“ (20 mm) directly
below the 1st mark on each side.
5. Drill a ¼” hole in the wall at each of the four
pencil marks.
6. Hammer the 4 wall mount anchors into the holes
- the anchors should be flush with the wall.
7. Now, using a Philips screwdriver, screw
the wall brackets in place with the
screws going into the anchors.
8. Tilting the bottom of the BAR1 slightly
away from the wall, guide the brackets
into the matching holes on the back of
the BAR1. The BAR1 is now securely
wall mounted.
NOTES
The supplied mounting kit can be used for typical drywall construction. Mounting to wood, concrete,
brick or other types of wall construction will require different hardware. Roth AV recommends seeking
professional assistance for such installations. The instructions on this page and the supplied wall mount kit
are only for the vertical wall mount. Professional assistance is required for other mounting or installation
orientations (e.g., horizontal, tilted).
1. Find centerline
of TV.
3. Make a pencil
mark on each side
of centerline.
X/2”
X/2”
+
+
+
+
+
+
10-7/16”
10-7/16”
10-7/16”
10-7/16”
1-1/2”
or more
25/32”
2. Make a pencil mark
1-1/2” or m ore below
the bottom of TV.
4. Make another pencil mark
on each side of centerline.
1-1/2”
or more
X”
Roth SoundBar Manual EH.indd 8
7/3/11 11:20:07
