USER MANUAL
ENGLISH
rothaudio.co.uk
| 9
Setup Instructions
1.
Unpack all the parts noted on page 5.
2.
If your TV has a headphone output, plug the supplied 3.5 mm mini stereo cable into the headphone jack output
of your TV and the other end goes to the Input 3 jack on the back of your BAR1 (shown below). This method will
disable your TV’s sound system and allow direct control of the BAR1 audio with your TV’s remote control.
3.
If your TV does not have a headphone output and you are using a set top box, plug one end of the included RCA
cable into the audio outputs of your set top box and the other end into Input 1 on the back of your BAR1. The
BAR1 remote control and the control buttons on the front panel of the BAR1 will always function no matter what
the audio input source is.
[Note] Some TV’s do not have a headphone output but do have Audio outputs with RCA jacks. You can connect them to Input 1 by using the RCA cable. This will
also work fine except that the BAR1 volume must now be adjusted using the BAR1 remote.
4.
The remaining inputs (Input 2) can be attached to Blu-ray, DVD or CD players or to personal music players.
5.
Install the table stands and plug the BAR1 power cord into the wall.
6.
Find a convenient location in the room for the Subwoofer and plug its power cord into the wall.
7.
The BAR1 and Subwoofer should automatically link together. Leave the Subwoofer on – it will go into a low power
consumption mode when not in use but will wake up automatically when a signal is present.
3.5 mm Mini Stereo Cable
Input 1
Input 2
LR
LR
Roth SoundBar Manual EH.indd 9
7/3/11 11:20:10
