ENGLISH
25
If battery fluid leaks out and comes into contact with
your skin, rinse immediately with plenty of water. If bat-
tery fluid leaks out and comes into contact with your
eyes, wash them with clean water and seek medical
attention immediately!
Transporting li-ion battery packs:
The contained lithium-ion batteries are subject to the Dan-
gerous Goods Legislation requirements. The user can transport the batteries by road without fur-
ther requirements. When being transported by third parties (e.g.: air transport or forwarding
agency), special requirements on packaging and labelling must be observed. For preparation of
the item being shipped, consulting an expert for hazardous material is required. Only send the
battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-circuiting (e.g. by protecting them with ad-
hesive tape).
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
1.4
Safety devices
Danger!
These devices are required for the machine's safe operation and may not
be removed or rendered inoperative!
The machine is equipped with the following safety devices:
- Upper stationary saw guard
- Lower retractable saw guard
- Large base plate
- Handles
- Index mechanism and brake
- Hose connector
1.5
Residual risks
Danger!
Even if used in accordance with its intended purpose and despite conform-
ing with the safety instructions, residual risks caused by the intended use will always
remain!
- Jamming of the saw blade when sawing long bar materials of non-leveled support points.
- Pinching body parts in the area of the hinge 22 (fig. 6).
- Touch the saw blade with the protective hood open on the guide rail.
- Touching the saw blade in the vicinity of the starting aperture below the base plate.
- Touching the part of the saw blade that protrudes below the workpiece when cutting.
- Touching of turning parts from the side: saw blade, clamping flange and flange screw.
- Machine backlash if the blade gets stuck in the workpiece.
- Breakage of the saw blade and risk of the blade or pieces of the blade being hurled away.
- Accidental activation if rechargeable battery is not unplugged.
- Hearing can be impaired when working for long periods without ear protectors.
- Emission of harmful wood dusts during longer operation without extraction.
2
Technical Data PIPECUT mini
(A)
No. PIPECUT mini basic ................................................. 1300006043
Nominal voltage............................................................... 18 V d.c.
Saw blade speed while idling .......................................... 4150 min
-1
Cutting depth 0º/45 .......................................................... 43/29 mm (1 11/16, 1 9/64 in.)
Summary of Contents for 1000003165
Page 415: ...NOTES ...
