ENGLISH
11
1
Safety Notes
1.1
Intended use
The diamond wet drilling machine RODIADRILL Ceramic is suitable for manual drilling of holes
of up to
Ø
67 mm in diameter and when using a RODIACUT drill stand. A ROTHENBERGER
centering aid can be used as an optional accessory. The drill holes that are created have
smooth walls. The valid regulations are to be observed for plugging. Persons under the age of
18 are not to use the equipment.
1.2
General Power Tool Safety Warnings
WARNING! Read all safety warnings, instructions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all instructions listed below may result in electric shock, fire and/or serious inju-
ry.
Save all warnings and instructions for future reference.
The term “power tool” in the warnings refers to your electrically-operated (corded) power tool or
battery-operated (cordless) power tool.
1) Work area safety
a)
Keep work area clean and well lit.
Cluttered and dark areas invite accidents.
b)
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools create sparks which may ignite the dust or
fumes.
c)
Keep children and bystanders away while operating a power tool.
Distractions can
cause you to lose control.
2) Electrical safety
a)
Power tool plugs must match the outlet. Never modify the plug in any way. Do not use
any adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching
outlets will reduce risk of electric shock.
b)
Avoid body contact with earthed or grounded surfaces, such as pipes, radiators,
ranges and refrigerators.
There is an increased risk of electric shock if your body is
earthed or grounded.
c)
Do not expose power tools to rain or wet conditions.
Water entering a power tool will in-
crease the risk of electric shock.
d)
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil, sharp edges and moving parts.
Damaged or
entangled cords increase the risk of electric shock.
e)
When operating a power tool outdoors only, use an extension cords suitable for out-
door use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f)
If operating a power tool in a damp location is unavoidable, use a residual current de-
vice (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
3) Personal safety
a)
Stay alert, watch what you are doing and use common sense when operating a power
tool. Do not use a power tool while you are tired or under the influence of drugs, al-
cohol or medication.
A momentary lack of attention while operating power tools may result
in serious personal injury.
b)
Use personal protective equipment. Always wear eye protection.
Protective equipment
such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropri-
ate conditions will reduce personal injuries.
c)
Prevent unintentional starting. Ensure the switch is in the off-position before connect-
ing to power source and/or battery pack, picking up or carrying the tool.
Carrying
power tools with your finger on the switch or energising power tools that have the switch on
invites accidents.
