Rothenberger ROBLAST JETTER, Manual

WARNINGS

•

: Do not operate the machine at over  

   pre-set engine speeds as this can cause serious pump  
   damage and will void the warranty.

•

: Do not operate the machine while  

   the frame is secured by transit only tie-down points as  
   this may lead to frame damage. 
 

• 

Machine should be mounted on a flat surface or level  

   mounting points to prevent any stress to the frame.

 
• 

Machine should be installed in a manner that allows     

   access to the pump and engine for maintenance  

   purposes. 

 
• 

Machine shall not be installed in an enclosed  

   environment.

•

: 

The high-pressure pump is  

   specifically factory set to operate at its rated 

   pressure.

. Tampering with the  

   pressure regulator can be very

.  

Consequently, it will void the warranty.

•

Furthermore, if the pressure does begin to decline,  

   check the nozzle for expected wear. If you find that 

   a nozzle is worn, it should be replaced immediately.  
   Using the machine with an incorrect nozzle size can  
   be very 

to the operator and will void  

   the warranty.

JETTER DAILY CHECKLIST

1. Check pump oil level. 

2. Check engine oil level. 

3. Check nozzle for wear. 

4. Check all high-pressure components for any leaks,  
    damage, wear or corrosion, such as the gun/lance,  

    jetting hose and connections, and all fittings.

5. Check the water filter and clean when necessary.

6. Check unloader and safety valve for any leaks. 

7. Check the hose marking that marks the last  
    metre of the hose and replace if worn.

of any abrasion on the hose and replace  

    immediately if damaged. Remember to

.

REGULAR SERVICE

All professional machines must be serviced thoroughly 

every 6 months, or 100 hours, whichever comes first. 
Use an approved and qualified ROTHENBERGER service 

agent. Furthermore, the service should include the 
engine manufacturer’s recommendations. Please see 
the separate Engine Manual for further details, along 
with the following:

1. Change pump oil.

2. Change the engine oil if required. Please refer to  
    the engine manual for schedule.

3. Check filter for foreign debris.

4. Check unloader and safety valve for leaks.

5. Check all high-pressure components, such as the  
    hose, for leaks, damage, wear or corrosion, and  
    replace when applicable.

6. Replace nozzles when necessary.

Contact your local 

SPITWATER

 agent to book in your 

service:  

1800 172 005 

www.spitwater.com.au 

Register your 

ROBLAST 5000

 jetter at

ivegota.spitwater.com.au

17