20
ENGLISH
3. Disconnect or close the return pipe and attach a drain hose. Additionally, the hose must lead
to a drain of sufficient dimensions and be fastened.
4. When water pressure is low, rinse the heating system section by section.
5. Diagram of a heating system.
1. Micro-filter
2. TW-distributor
3. Pipe disconnector
4. Cleaning compressor
5. Floor heating circuit
6. Connection hose
7. Drain hose
8. Stop valve
9. Drainage
Rinsing process:
1. Set the switch to Rinse.
2. Press the ON/OFF
program button. The compressor fills the pressure vessel automati-
cally.
When filling the compressed air reservoir, do not pull the electrical plug when the
compressor is running.
3. Open the water feed.
4. Press the program button “Water + Air (pulsing)”
. And perform the rinse.
5. The rinsing process is over when no more discharges are visible. For this it is recommended
that the water escaping from the tapping points be allowed to flow through a mesh with a
width of about 100
µ
l.
6. After the rinse, the rinse compressor must be turned off.
7. Then close the water feed.
8. Then disconnect the ROPULS eDM from the power supply.
9. The compressor must not fill. The filling process (8 bar) must be completed. The rinsing ma-
chine must be separated from the test pipe, and all connections must be properly installed.
Then a leak test is necessary.
10. After the rinsing process, a rinsing log (certificate) must be made out. The original copy must
remain with the customer and the carbon copy with the company performing the work.
6.6
Logging
Your ROPULS eDM records data during the flushing process.
To create the flushing log, please call up these data using your ROPULS app / Windows soft-
ware over Bluetooth on your tablet / Smartphone / PC.
A PDF file is created as a flushing log together with the manually filled out fields.
6.7
Data transmission
It is necessary for the ROPULS to be in Standby mode to be in a position
to send or receive data packages at a peripheral device.
To do this the device must be supplied with power and then switched off.
The display shows “- -“ in Standby mode.
Summary of Contents for ROPULS AUS
Page 219: ...NOTES ...
