RFD OPERATOR MANUAL
6-36
6. POST OPERATIONAL PROCEDURES.
6.1. SECURING THE SYSTEM.
6.1.1.
Turn the Controller Unit off and remove the Antenna Assembly. This action
disables the Controller Unit.
6.1.2.
Replace the dust cover on the antenna / battery charger connector on the
Controller Unit and replace the red plastic cap on the Antenna Assembly.
6.1.3.
Remove the Antenna Assemblies from the Detonator Units. This action turns
off the Detonator Units.
6.1.4.
Replace the dust cover on the antenna / battery charger connector on the
Detonator Units and replace the red plastic cap on the Antenna Assembly.
6.2. PHYSICAL
INSPECTION.
6.2.1.
Inspect the Controller Unit and Detonator Units for physical damage.
6.2.2.
Inspect the units for dirt or corrosion around/on connector pins and vent.
6.2.3.
Replace any unit found to have damage. Return unit to Manufacturer.
6.2.4.
Clean units using a soft bristle brush.
6.2.5.
If a unit cannot be cleaned by brushing, make sure the vent is closed securely
and wash units in warm soapy water.
6.2.6.
Rinse units with clean water and dry thoroughly.
6.2.7.
Inspect units for damage. Replace as necessary.
6.3. PACKAGING.
6.3.1.
Re-package all components in carrying case.
6.4. MAINTENANCE & EQUIPMENT STORAGE.
6.4.1.
Periodic battery charging.
6.4.2.
Check for signs of corrosion around and on connector pins.
Summary of Contents for REMOTE FIRING DEVICE
