9
U
U
H
H
S
S
S
S
y
y
s
s
t
t
e
e
m
m
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
If not UHS please see next pages.
Initial Start-Up
From the moment your spa is plug in, it is automatically pre-set to operate until it reaches 100°F (38°C). This process could
take up to 20 hours depending on the initial water temperature. The spa is also preset to filter the water for 1 hour per
day (30) and the clock starts the second you plug it in.
Temperature Adjustment 60°F-104°F (15°C-40°C)
When either of the Accu-temp pads
are pressed once, the LCD will display the temperature which has been set.
Each time either one of these pads are pressed again, the temperature will change by 1°. After 5 seconds, the LCD will
automatically display the current spa temperature.
Jets.
Press the
pad to run the pump on and off. If left running, the pump will automatically turn off after 15 minutes.
Light.
Press the
pad to turn the spa light on and off. If left on, the light will automatically turn off after 4 hours.
Spa Water Maintenance. This function enables you to program the amount of water filtration time.
Press
or
and then
to enter the programming mode. Once in the programming mode press
or
to select
the filtration time.
00 In this mode there is no additional filtration.
30 In this mode the water will be filtered for 1 hour every day.
60 In this mode the water will be filtered for 2 hours every day.
To exit press
Standby Mode
This function allows you to disable the equipment when the filter needs to be serviced without disturbing the already
programmed filtration time. Press
or
and then
to enter the standby mode. All spa functions are disabled except
for freeze control. To exit from standby press any button.
Display Messages:
OH “Overheat” (spa is deactivated)
DO NOT ENTER THE WATER. If the spa water has reached 108°F (44°C), remove the spa cover to cool the water. The spa
will remain shut down until the water and the heater sensor cools to 104°F (40°C). At that point press any button to reset
the spa. If the spa will not reset, shut off the power to the spa and call your dealer or service organization.
S
N
“Non Functional High Temp Sensor” (heater is deactivated)
Open sensor. Call your dealer or service center.
XXX-UHS-XX-X
1 0 2