7
Important Safety Instructions
Manufacturer’s warnings
In addition to the Safety Instructions found in this manual, these warnings have
been assembled to help you enjoy the use of your Roto Spa hot tub. Reading and
understanding these warnings will allow you to reduce the risk of causing
inadvertent damage to your Roto Spa hot tub, your surroundings, or yourself.
Read these warnings carefully.
The water level must be maintained at 6cm above the skimmer height. Do not let
the water level fall below the height of the skimmer level. If the water level falls
below the skimmer level this air will enter the system and may result in an
overheat situation and void the warranty.
Always turn off your Roto Spa before draining and filling process.
Maintain proper water pH (7.4-7.6), to high a pH level can damage the heater and
void warranty.
Never use an extension cord to connect the Roto Spa to the power source.
Using an extension cord will void your warranty.
Do not operate without an approved ground fault circuit interrupter. This
safety device shuts off the power immediately in the event of an electrical
short.
Install the Roto spa only on floors or areas that can withstand repeated exposure
to water. Splashing, dripping, filling and draining are routine operations, which
spill water. Equipment failure may also cause substantial water spillage. If located
in a multiple floor structure, objects on the floor below should be protected in the
event of a major spill.
Certain objects reflect and concentrate the sun’s rays. Close proximity of the Roto
Spa cover to such objects should be avoided or damage may incur.
When changing the water or storing the Roto spa
do not leave in direct sunlight
.
This may cause damage to the shell of the Roto spa.
Do not open the controller. There are no user serviceable parts inside. Opening
the control unit will void the warranty.
